We Welcome International Orders
Serving over 145 Countries and counting...
HANDcraft™ Ball Valve Heater
Never have your oils or waxes set up in your Ball Valve again with our HANDcraft™ Ball Valve Band Heater .
45W 120V band heater comes complete with Velcro strips that fit perfectly around 3/4" or 1" Metal Ball Valves.
Note:
Not for use with Plastic Ball Valves
All prices are USD. Adding items to cart will redirect you to our secure shopping cart at soapequipment.com
HANDcraft™ Heated Valve Assembly
This is perfect for companies requiring constant heat from tank to jar or mold. Never have your oils or waxes set up in your Ball Valve again.
- Assembly is simple to remove and replace with our standard 3 way Ball Valve for different operations.
- Works with all of our Oil Melting Tanks.
- Comes pre-assembled and is ready to install on your Oil Melting Tank (Oil/Wax Melter).
- Just plug in the HANDcraft™ Ball Valve Heater and you're ready to pour.
- Includes 1 ½” Stainless Steel Reducer Bell Coupling w/ ¾” Brass Ball Valve and 90 degree brass elbow, HANDcraft™ Ball Valve Heater, and Foam Insulation for the Stainless Steel Bell Coupling.
All prices are USD. Adding items to cart will redirect you to our secure shopping cart at soapequipment.com
Reducer for 1.5 inch Ball Valve
This reducer is great for filling your bottles, jars, candle molds, M&P molds, etc. right from your Oil Melting Tank.
Description:
- For those businesses still growing and not quite ready for our Easy Fill Bottler, this is a great way to start filling your containers, bottles, jars or even soap and candle molds.
- This will save considerable time on filling your jars, bottles, soap and candle molds.
- This is much more efficient method and much less mess than pouring your product into a smaller container to then fill your bottles or molds.
- Fits right into our 1 1/2" (38mm) Ball Valve. This allows you to turn the 1 1/2" valve fully on and then just adjust the fluid flow or cut the flow on and off using the smaller 1/2" (13mm) Ball Valve.
Specifications:
- Reduction from 1 1/2" (38mm) Ball Valve to a 3/8" (10mm) flow.
- Fully assembled, no pipe cement or Teflon tape needed to attach to 1 1/2" (38mm) Ball Valve.
- Will handle temps up to 220 F (104 C).
- Will handle most acids and alkalis.
Instructions for using Ball Valve Reducer:
- Make sure the reducer valve is closed 1st before installing.
- Thread the reducer into the ball valve, hand tight, so it is easy to remove.
- Plastic to plastic makes a good seal without Teflon tape and does not need to be extremely tight.
- Open the big ball valve and then start dispensing using the small ball valve on the reducer.
- When you are done, close the big valve and unscrew the reducer.
- Simple to clean - Just open the small valve and run a dowel rod or twist up a piece of rag and run through it to clean most of the oil, wax, cream, etc. Then wash and you are ready for your next batch.
All prices are USD. Adding items to cart will redirect you to our secure shopping cart at soapequipment.com
See our Tanks & other Accessories